Glass fibre concrete">reinforced concrete (GRC), also known as glassfibre reinforced concrete or GFRC, consists of high-strength, alkali-resistant glass fibres embedded in a cementitious matrix. The composite is classified for mechanical performance under BS EN 15191, a European standard covering precast concrete products that deals specifically with the classification of GRC performance. The fibres act as the principal load-carrying element, while the surrounding cementitious matrix holds them in position, transfers load between fibres and protects them from environmental exposure. This combination allows manufacturers to produce thin, lightweight panels with tensile strength that a plain cementitious mix cannot achieve on its own — a property that has made GRC a standard material for exterior facade panels and architectural precast components.
What makes the glass fibres in GRC alkali-resistant?
Early glass fibre reinforcement suffered from poor durability because the alkalinity of cement reacted with the silica in the glass, triggering an alkali-silica reaction that caused damaging internal swelling. This limitation was resolved in the 1970s with the commercial introduction of alkali-resistant (AR) glass fibres, produced by adding zirconia to the glass composition. The resistance to alkali attack scales with zirconia content: fibres must contain more than 16% zirconia to comply with internationally recognised specifications issued by bodies such as EN, ASTM, PCI and GRCA.
How is GRC classified under BS EN 15191?
BS EN 15191 was published in 2010 as the European standard for classifying glassfibre reinforced concrete performance in precast concrete products, and it applies only where EN 1169 requirements are followed; it does not prescribe design methods. The standard has since been superseded by an updated version, EN 15191:2024, adopted nationally as SIST EN 15191:2025, which keeps the same scope: classification of GRC performance to support the design process for precast GRC components. Key elements of the classification system include:
- Bending-stress classes based on limit of proportionality and modulus of rupture, with material classes such as 6/8, 7/10 and 7/14
- Application-specific parameters covering long-term weathering and additional durability demands
- Special performance attributes where required, including fire resistance, frost resistance or water impermeability
- Test methods referenced from EN 1170 and EN 14649 for evaluating GRC characteristics and glassfibre strength retention
- Glassfibre quality requirements defined in EN 15422, with strength retention verified via the SIC test described in EN 14649
Where is GRC used in construction?
GRC without steel framing is commonly specified for decorative, non-structural elements such as window trims, decorative columns, exterior friezes and limestone-like wall panels. Facade cladding remains the dominant application, alongside architectural elements with complex geometries, and infrastructure components such as drainage channels and street furniture that benefit from the material's strength-to-weight ratio. Partition walls and modular systems also use GRC where a classified, repeatable performance level is required.
From a materials-engineering standpoint, GRC behaves differently from reinforced metal structures. While metals typically exhibit yielding and plastic deformation, fibre-reinforced composites like GRC are largely elastic in their tensile stress-strain response. Depending on load type and severity, a GRC laminate may show gradual property deterioration rather than sudden catastrophic failure. The material is also noted for non-corroding behaviour, high damping capacity and a low coefficient of thermal expansion — characteristics relevant when specifying precast facade elements alongside other concrete construction systems such as UHPC or carbon-reinforced concrete.
For specifiers comparing lightweight cladding options, GRC's classification system under BS EN 15191 provides a documented basis for selecting material classes matched to application demands, from standard facade panels to components requiring additional fire or frost resistance.

