Drying shrinkage and autogenous shrinkage are two distinct volume-reduction mechanisms in hardening concrete, and both can trigger restraint cracking when movement is held back by reinforcement, formwork, or adjoining structural elements. Autogenous shrinkage occurs inside the cement paste itself, driven by the consumption of water during hydration — it happens regardless of what the surrounding environment is doing. Drying shrinkage, by contrast, is caused by moisture migrating out of the hardened concrete toward the surface and evaporating into the air.

Autogenous shrinkage is self-desiccation: as cement hydrates, it binds free water in the paste, pulling moisture out of the capillary pore structure and causing the paste to contract from within. Because this process is internal, it is not caused by exchange of moisture with the environment and proceeds at a rate governed largely by hydration chemistry rather than ambient conditions.

Read morePlastic Shrinkage Cracking: Why Fresh Concrete Cracks Within Hours — and How to Stop It

Drying shrinkage, on the other hand, develops slowly because it depends on water physically migrating through the hardened concrete matrix to reach the surface, where it can evaporate. This makes drying shrinkage strongly influenced by two practical factors: the size of the member — thicker sections dry out more slowly and shrink less at the surface over a given period — and the relative humidity of the surrounding environment, where drier air accelerates moisture loss and increases drying shrinkage.

Restraint cracking appears when shrinkage movement — whether from the autogenous or the drying component — is prevented by reinforcement, by bond to a substrate, or by connection to adjacent, already-hardened concrete. Early-age cracking risk from autogenous shrinkage is linked to cement hydration and mix design, not curing exposure. Drying shrinkage risk builds over a longer period and is directly manageable through member thickness and control of ambient humidity at the exposed surface. Thinner, high-surface-area elements such as screeds or thin toppings are more exposed to drying shrinkage effects than massive sections.

Treat autogenous and drying shrinkage as two separate risks, not one combined allowance. Autogenous shrinkage is locked in by the mix design and hydration chemistry before the pour is even finished curing — control it through cement selection and water/cement ratio at the design stage. Drying shrinkage unfolds over weeks, driven by member thickness and ambient humidity — control it through protection of exposed surfaces.