Mycelium-based composites are produced by letting fungal filaments grow through a loose agricultural substrate — sawdust, straw, hemp fibre, corn residues, rice husks or similar lignocellulosic material — until the branching network binds the particles into a solid, lightweight block. The resulting material is then dried or heat-treated to stop further growth. Research reviewed in Frontiers in Materials frames these composites as a low-energy bio-fabrication route that converts agricultural by-products into alternatives to energy-intensive synthetic materials.

How are mycelium composites actually made? Production follows a broadly consistent sequence, though outcomes vary significantly depending on fungal species, substrate choice and processing conditions. The main stages are: Substrate preparation — agricultural, forestry or industrial plant residues are cleaned, pasteurised or sterilised to limit competing organisms. Inoculation — a selected fungal culture is introduced into the prepared substrate; species and strain influence growth rate, bonding and surface finish. Moulding — the inoculated mixture is placed into a mould or form, allowing the material to grow directly into a block, panel, tile or custom component. Growth phase — under controlled temperature, humidity and ventilation, the mycelium spreads through the substrate and binds the particles together. Drying or heat treatment — growth is halted and the material stabilised for handling and use.

Read moreBio-Based Epoxy Resins: How Lignin and Plant Oils Are Replacing BPA in Construction Composites

What does the research say about material properties? Peer-reviewed work on mycelium-based bio-composites has catalogued mechanical properties across different fungal species and process conditions. Researchers in the Frontiers in Materials review compile mechanical property data for mycelium-based foams and mycelium-based sandwich composites, and separately characterise mycelium fibre properties and the mechanical behaviour of Pleurotus-based materials under varying growth conditions.

Where does the material fit — and where does it not? A mycelium composite's final performance depends on both the fungal binder and the plant-based substrate, and on how it is grown, pressed, dried, treated and protected afterward. That dependency on process variables means performance data from one product or study does not necessarily transfer to another. Current evidence suggests mycelium composites are suited to protected, non-structural applications.